|
Pipeline Equipment: The pipe facing machines are built to cut precision chamfer on pipe ends with a thickness up to 1" 1/2. In the same time the internal pipe is perfectly centred to the machine. The chamfer is made by means of widia cutting tools [up to six] hold by a tool holder fixed to a rotating platform [chuck] and operating simultaneously, in order to perform the wanted chamfer. The chuck is driven by two hydraulic motors operated through a valve on the hydraulic panel.
-
The power and the speed of the motors is generated by a hydraulic power unit.
-
The speed of the motors can be adjusted by a valve on the hydraulic panel.
-
The chuck shift is done by a hydraulic piston fed from a low pressure oil circuit.
-
The shifting speed can be adjusted by a micrometric flow regulator.
-
The facing machine is feeded by the hydraulic power unit that feeds the hydraulic motors through a high pressure circuit (170 bar).
|
|
N°1 12”- 18” Pipe Facing Machine (CE mark)
with the following characteristics:
-
Double hydraulic 250 c.c motor.
-
xpander with 6 + 6 pistons.
-
N°4 Tool holders drawer type.
-
High performance speed (oil request 160 lt/min at 140 Bar).
-
The machine is settled at the pipe size 12” and the thickness requested by the customer.
-
The machine is equipped with shoes, spacers and bolts suitable to cover the range 12”- 18”.
-
N°1 Soundproof Diesel Power Unit, with the following characteristics:
-
The machine is suitable for any type of PFM
-
The machine is equipped with: air cooled VM engine 75 Hp at 1600 rpm,
-
Denison oil pump 200 lt/1’ at 1600 RPM
-
400 lt oil tank
-
Air heat exchanger
|
